P TWO 24V P812002 2-channel amplifier with Ultra HD resolution 24 Volt

Helix

Discontinued

Your price:
€ 749,00
Price per single item (VAT included)

Helix P TWO P812002 2-channel high-resolution amplifier, Ultra HD Class D

Plenty of power and sensitivity: the new P TWO combines two important characteristics in an absolutely unique way. Thanks to its RMS output power of 2 x 490 Watts at 2 Ohm, this compact amplifier is able to drive even powerful subwoofers. The technical design is literally predestined for all woofers with dual voice coil 2 x 2 Ohm such as the new HELIX Q subwoofers.

Despite its sheer power, P TWO is not merely a subwoofer amplifier. On the contrary, the Ultra HD Class D concept combines an extended frequency response above 40 kHz with high damping factor, minimal distortion and excellent signal-to-noise ratio. Therefore, this amplifier is equally a perfect companion for heavy-duty front speakers in audiophile system concepts.

Ultra HD Class D amplification technology

Compared to conventional Class D amplifiers, this concept achieves an extended frequency response above 40 kHz in combination with reduced distortion thanks to an advanced integrated feedback design. Ultra HD Class D achieves exceptional "Class AB" sound quality combined with the efficiency of a Class D amplifier.

Signal converters with native 32 bit resolution

HELIX P TWO uses for the optical input a latest generation DA signal converter with native 32 bit resolution instead of the common 24 bit. The result is unprecedented precision in signal conversion that particularly optimizes sound quality at lower signal levels.

Intelligent high-level input

The latest generation of OE car radios incorporates sophisticated diagnostic capabilities for connected speakers. If a common amplifier is connected, error messages and loss of specific features (e.g. fade function) appear quite often - but not with the P TWO. The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without unnecessarily loading the OE radio speaker outputs at high volumes.

Start-Stop functionality

HELIX P TWO's switched power supply ensures operation even if the battery voltage drops to 6 Volts during engine cranking.

Helix
SRC Remote subwoofer level control for Helix amplifiers Helix
Helix SRC Remote subwoofer level control for Helix amplifiers
Price incl. VAT
€ 14,00

Manuale utente

n-20190507144632-ba-helix-p-two.pdf

Helix P TWO technical specifications

Output power RMS / max.

@ 4 Ohms 2 x 280 / 560 Watts

@ 2 Ohms 2 x 490 / 980 Watts

Amplifier technology Ultra HD Class D

Inputs 2 x RCA / Cinch
2 x Highlevel speaker input
1 x Optical SPDIF (28 - 96 kHz)
1 x Remote In
1 x Remote control input

Input sensitivity RCA / Cinch 2 - 8 Volts

Highlevel 5 - 20 Volts

Input impedance RCA / Cinch 10 kOhms

Input impedance highlevel 13 Ohms

Outputs 2 x Speaker output

Signal converter for digital input BurrBrown 32 Bit DA converter

Frequency response 10 Hz - 40,000 Hz

Bass boost 0 - 9 dB / 40 Hz - 120 Hz

Highpass 15 Hz - 4,000 Hz adjustable

Lowpass 15 Hz - 4,000 Hz adjustable

Bandpass 15 Hz - 4,000 Hz adjustable

Slope high - / lowpass Butterworth 12 dB/Oct.

Slope subsonic / lowpass -

Signal-to-noise ratio digital input 105 dB (A-weighted)

Signal-to-noise ratio analog input 105 dB (A-weighted)

Distortion (THD) < 0.005 %

Damping factor > 200

Operating voltage 10.5 - 16 Volts (max. 5 sec. down to 6 Volts)

Idle current 2400 mA

Fuse 3 x 30 A LP-Mini-fuse (APS)

Additional features Active, adjustable crossover, bass boost, input mode switch, highlevel input with Advanced Diagnostics Error Protection (ADEP), Auto Remote switch, SPDIF Direct In switch, cable remote control for volume adjustment

Dimensions (H x W x D) 50 x 260 x 190 mm / 1.97 x 10.24 x 7.48"

Discontinued