G TWO compact 2-channel amplifier with active crossover

Helix

Discontinued

Your price:
€ 265,00
Price per single item (VAT included)
Amplifier Type
2 channels
RMS Power 4 Ohm
2x125 Watt
RMS Power 2 Ohm
2x200 Watt
Mono RMS Power 4Ω
1x400 Watt
Crossover
Yes
Signal-to-Noise Ratio
106 dB S/N
Total Harmonic Distortion
0,02 % THD
Size
334 x 241 x 57 mm

Helix G TWO 2-channel amplifier from the G series with compact design and illuminated logo

Start-Stop function up to 6V power supply voltage
Intelligent high-level input with ADEP circuit (Advanced Diagnostics Error Protection)
Fully active crossover with highpass, lowpass, bandpass and bass boost
Extremely stable output stage with high-current power transistors
Remote cable control for volume adjustment of channels A and B
"Input mode" switch for flexible input signal routing
Input sensitivity at maximum level up to 14 Volt max.
2-channel pre-channel for connecting additional amplifiers
SMD (Surface Mounted Device) production technology combines minimum space required with maximum reliability
Exclusive compact and clean design with illuminated HELIX logo

Special features of the Helix G TWO amplifier:

Intelligent high-level input
The latest generation of OE car radios incorporates sophisticated diagnostic options for connected speakers. If a common amplifier is connected, error messages and loss of specific features (for example the fader function) appear quite often - but not with the G TWO.
The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without unnecessarily loading the OE radio speaker outputs in case of high volumes.

Start-Stop functionality
HELIX G TWO's switched power supply ensures operation even when battery voltage drops to 6 Volt during engine cranking.

Manuale utente

n-20190508095251-ba-helix-g-two.pdf

Helix G TWO technical specifications

Class AB amplifier technology

RMS / max output power
- @ 4 Ohm 2 x 125/250 Watt
- @ 2 Ohm 2 x 200/400 Watt
- @ 1 Ohm 2 x 300/600 Watt
- bridged @ 4 Ohm 1 x 400/800 Watt
- bridged @ 2 Ohms 1 x 600 / 1,200 Watt

Inputs
2 x RCA / Cinch
2 x High-level speaker
1 x Remote In
1 x Remote control input

RCA / Cinch input sensitivity 1 - 6 Volt
High-level 2.5 - 14 Volt
RCA / Cinch input impedance 30 kOhms
High-level input impedance 12 Ohm
Outputs 2 x Speaker output
2 x RCA / Cinch
RCA / Cinch output voltage 1 - 6 Volts RMS
Signal converter for digital input
Frequency response 10 Hz - 40,000 Hz
Bass boost 0 to 12 dB / 45 Hz
Highpass 15 Hz - 4,000 Hz adjustable
Lowpass 40 Hz - 4,000 Hz adjustable
Bandpass 15 Hz - 4,000 Hz adjustable
Subsonic
Phase
High / low slope Butterworth 12 dB / Oct.
Subsonic / lowpass slope
Digital input signal-to-noise ratio
Analog input signal-to-noise ratio 106 dB (A-weighted)
Distortion (THD) 0.02%
Damping factor 200
Operating voltage 9.6 - 16 Volt (maximum 5 seconds down to 6 Volt)
Idle current 1000 mA
Fuse 2 x 30 A Maxi-fuse (APX)
Additional functions Active crossover, bass boost, input mode switch, high-level input with auto-on function and advanced diagnostic error protection (ADEP), Start-Stop functionality, remote control for volume adjustment
Dimensions (W x D x H) 57 x 334 x 241 mm / 2.24 x 13.15 x 9.50 "

Discontinued