G ONE mono amplifier with ADEP circuit and active crossover

Helix

Discontinued

Your price:
€ 329,00
Price per single item (VAT included)
Amplifier Type
1 channel
Crossover
Yes
RMS Power 4 Ohm
1x390 Watt
Signal-to-Noise Ratio
95 dB S/N
RMS Power 2 Ohm
1x675 Watt
Total Harmonic Distortion
0,05 % THD
RMS Power 1 Ohm
1x920 Watt
MAX Power Consumption
100 Ampere
Size
334 x 241 x 57 mm

Helix G ONE monochannel amplifier G series

Start-Stop function up to 6V supply voltage
Intelligent high level input with ADEP circuit (Advanced Diagnostics Error Protection)
Fully active crossover with subwoofer subsonic, lowpass, bass with adjustable center frequency and phase
Extremely stable output stage with high current power transistors
Cable remote control for volume adjustment
"Input mode" switch for flexible input signal routing
Input sensitivity of maximum level up to 14 Volt max.
SMD (Surface Mounted Device) production technology combines minimal space required with maximum reliability
Exclusive compact and clean design with illuminated HELIX logo

Special features of the Helix G ONE amplifier:

Intelligent highlevel input
The latest generation of OE car radios incorporates sophisticated diagnostic capabilities for connected speakers. If a common amplifier is connected, error messages and loss of specific features (for example the fader function) appear quite often - but not with G ONE.
The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the OE radio speaker outputs under unnecessarily high volumes.

Start-Stop functionality
HELIX G ONE's switched power supply ensures operation even if battery voltage drops to 6 Volts during engine cranking.

Manuale utente

n-20190508101415-ba-helix-g-one.pdf

Helix G ONE technical specifications

Amplifier technology Class D
Output power RMS / max.
- @ 4 Ohm 1 x 390/780 Watt
- @ 2 Ohm 1 x 675 / 1,350 Watt
- @ 1 Ohm 1 x 920 / 1,840 Watt
- bridged @ 4 Ohms -
- bridged @ 2 Ohms -

Inputs
2 x RCA / Cinch
2 x Speaker high level
1 x Remote In
1 x Remote control input

RCA / Cinch input sensitivity 1 - 6 Volt
Highlevel 2.5 - 14 Volt
RCA / Cinch input impedance 30 kOhms
High level input impedance 12 Ohm
Outputs 1 x Speaker output
RCA / Cinch output voltage
Signal converter for digital input
Frequency response 10 Hz - 250 Hz
Bass boost 0 - 12 dB / 25 Hz - 50 Hz
High pass
Lowpass 50 Hz - 250 Hz adjustable
Bandpass 10 Hz - 250 Hz adjustable
Subsonic 10 Hz - 50 Hz adjustable
Phase 0 - 180 ° adjustable
High / low slope
Subsonic / lowpass slope Butterworth 12 dB / Oct.
Digital input signal-to-noise ratio
Analog input signal-to-noise ratio 95 dB (A-weighted)
Distortion (THD) 0.05%
Damping factor 200
Operating voltage 9.6 - 16 Volt (maximum 5 seconds down to 6 Volt)
No-load current 1000 mA
Fuse 3 x 40 A Maxi-fuse (APX)
Additional functions Active crossover, adjustable, bass boost, input mode switch, high level input with auto-turn-on function and advanced diagnostic error protection (ADEP), Start-Stop functionality, remote bass volume control
Dimensions (W x D x H) 57 x 334 x 241 mm / 2.24 x 13.15 x 9.50 "

Discontinued