AP 560P&P IN Plug&Play extension cable for AP bit amplifiers, 560 cm

Audison

Discontinued

Your price:
€ 49,90
Price per single item (VAT included)

Audison AP 560P&P IN Plug&Play Extension Cable for AP bit amplifiers 560cm

Plug&Play wiring for AP bit amplifier connections. Guarantees complete freedom of amplifier positioning. The Extension cable with Plug&Play connections allows complete freedom of positioning for AP bit amplifiers. Two types of extensions are available: input only, to send exclusively the audio signal from the source to the AP bit amplifiers, or input/output to also carry the output signal from the AP bit to the factory audio system. To do this, the AP Extension Cables IN/OUT must be installed in combination with the AP Speakers Output Cables (see attached pdf).

Using the input/output, the installer has the freedom to choose which configuration to adopt. In fact, the AP Extension cables allow you to send each individual channel of the AP bit amplifier to any of the vehicle's speakers, thus leaving the freedom to create the desired configuration. For example: standard front (2ch TW+WF), multi-amplified front (2ch TW + 2ch WF), multi-amplified front with 4 bridged channels (130W @ 4ohm) for the woofers (2ch TW + 4ch bridge WF) and all other possible combinations.

The AP plug and play input/output wiring for Audison Prima series powered processors are available in the following sizes:

Catalogo cablaggi plug and play Audison Prima

20150211110007-060853-audison-prima-cartella-stampa-p-p-ita.pdf

Audison AP 560P&P IN Technical Specifications

  • Made with braided cables for effective noise suppression.
  • Length 5.6 m.
  • Anti-cut protective sheath.
  • High flexibility for maximum ease of installation.
  • No soldering required.
Discontinued