AP 160P&P I/O 160 cm extension cable

Audison

Discontinued

Your price:
€ 48,90
Price per single item (VAT included)

AP 160P&P I/O is an extension cable with Plug&Play connections that allows complete freedom of positioning for amplified processors of the AP bit series.

Two types of extensions are available: input only, to send exclusively the audio signal from the source to the AP bit amplifiers, or input/output to also convey the output signal of the AP bit to the factory audio system. To do this, the AP Extension Cables IN/OUT must be installed in combination with the AP Speakers Output Cables (see attached pdf).
By using the input/output, the installer has the freedom to choose which configuration to adopt. In fact, the AP Extension cables allow you to send each individual channel of the AP bit amplifier to any of the vehicle's speakers, thus leaving the freedom to achieve the desired configuration.
For example: standard front (2ch TW+WF), multi-amplified front (2ch TW + 2ch WF), multi-amplified front with 4 bridged channels (130W @ 4ohm) for the woofers (2ch TW + 4ch bridge WF) and all other possible combinations.

Technical Specifications AP 160P&P I/O:

  • Made with braided cables for effective noise suppression.
  • Length 1.6 m
  • Protective cut-resistant sheath.
  • High flexibility for maximum installation ease.
  • Dual connector In/Out to also receive the amplified signal from the AP bit amplifiers.
  • No soldering required

The AP plug and play input/output cables for amplified processors Audison Prima series are available in the following sizes:
AP 160P&P I/O ISO EXTENTION IN/OUT 160 cm
AP 260P&P I/O ISO EXTENTION IN/OUT 260 cm
AP 560P&P I/O ISO EXTENTION IN/OUT 560 cm

Catalogo cablaggi plug and play Audison Prima

20150207104301-audison-prima-cartella-stampa-p-p-cable-alta.pdf
Discontinued